Disturb Blown Attic Insulation To Run Wire

This almost seems like more work than it s worth but it s something i really want to do.

Disturb blown attic insulation to run wire.

Yes this should be corrected and it would be good to have the wiring and all the circuit connections inspected as well. The attic wiring should be protected and secured to ceiling joists or other wood structural supports. If you were going to have someone do it for you you wouldn t have to ask the question in the first place. For the center areas hold the hose level and blow in insulation evenly until you ve reached your level lines photo 6.

Ask question asked 4 years. Concealed knob and tube wiring shall not be used in the following. Blow in insulation until the hopper is empty. How to snake wires through insulation.

Nec 2008 394 12 uses not permitted. Locate the wall studs with a stud finder in the area where you re snaking your wires. Move across the attic until you ve hit your desired height at every point. I m not a fan of the answers hire a fill in the blank do it for you in reply to a diyer trying to do a little research into a project.

The staple gun should be loaded with wire staples designed for holding the size and type of wire you are running. Bring all of the wire up into the attic. Also it may not be as simple as stapling the wiring to the structural members. Then pivot in place and do the same thing to the other side.

Whenever i do attic wiring i remove the insulation and staple it to the ceiling joist. Do i just try to disturb the least amount of insulation. Place the electrical box that will contain the wiring for the device being installed against the wall where it s being installed. Do i make paths along where i need to go and then put the insulation back once i m done.

How to run data cable in an attic with blown fiberglass insulation. 5 hollow spaces of walls ceilings and attics where such spaces are insulated by loose rolled or foamed inplace insulating material that envelops the conductors. The following links will assist you with your electrical question. While one person holds the flashlight the other person should use a staple gun to run the wire along the rafters from one entry hole to the other.