This article is about a simple digital code lock using arduino.
Digital door lock system using arduino.
The arduino board is connected to an lcd and a servo motor.
This idea helps in the security of the locker s in the bank list of the components required for the project.
The aim is to control a door lock without keys but using a smart phone instead.
It will open your door only when the right password is entered and it will start beeping when a wrong password is entered.
Digital door lock using arduino as thefts are increasing day by day security is becoming a major concern nowadays.
The simply compile it then finally upload it to the atmega328 microcontroller.
By saddam oct 19 2015 34 digital code lock using arduino security is a major concern in our day to day life and digital locks have became an important part of these security systems.
Simply it s a digital door lock system which helps in the security of the door lock with the use of a digital keypad and by using the arduino uno board.
This is a simple project made with arduino uno r3.
In this project we will make a digital door lock system with keypad using arduino uno.
First of all we start from the brain of this project which is the arduino uno board.
There are separate keys for locking and unlocking the system.
Digital code lock or digital combination lock are a type of digital locks where a combination of digits characters or both are used for unlocking the lock.
The code for password based door lock security system using arduino keypad is given below.
Hello dear friends in this project i have tried to explain how to built a door lock security system with an arduino and keypad.
Connect pin 3 v0 to the middle pin of the 10kω potentiometer and connect the other two ends of the potentiometer to vcc and gnd.
The complete circuit diagram for our arduino based digital keypad door lock project is shown below.
Connect pin 4 rs to the pin 9 of the.
Download the library for keypad h from below.
Smart bt door lock simple arduino project showcase by arun.
Here the code consists of a combination of digits from 1 to 6.
Connect pin 2 vdd or vcc to the 5v of the arduino.
Connect pin 1 vee to the ground.
The servo motor is used to push lock or pull unlock the latch on the door.
One such digital code lock is imitated in this project using arduino board and a matrix keypad.
Digital door lock using arduino.